The menu has been divided into four sections: profile, settings, preferences and system. It is set up like the old one, by pressing the trigger at power-on to enter the menu. – A bottomwork equipped with a o’ring to provide o’ringing of the overall regulator. – A Retainer serves as a guide for the piston.
– A screw with a o’ring is the junction between the starter housing and the controller to maintain the regulator. The controller is identical to the previous. The solenoid can always be dismantled and is identical to the former except for the central part which is rigid plastic instead of metal with the letter M from MacDec molded on its surface.
This may seem like a lot but after some disassembly/reassembly, you will be able to do it with ease. – The cover drive, equipped with a o’ring.Ī total of 21 o’rings for 8 parts. – The Powertube cap equipped with a gasket. Again these two o’rings are vital to the o’ring between the two pressure chambers. These three o’rings are vital to propel the bolt by the solenoid. In case of leakage, the barrel, the inner o’ring must be checked to see replaced. – The bolt, which is equipped with three o’rings which serve two bumper. The bolt is very complex and require careful and regular maintenance. We note that the ASA KNOB is longer than the old model. A small advice: when you have finished playing with your gun, it is important to purge your launcher otherwise you risk to shear the o’ring. It is equipped with an o’ring to properly seal in the closed position. It is a screw (ASA knob) which pushes the pin of the bottle. They cover the eyes and ball detent, also the same design as for the Clone GT. Just turn it clockwise to tighten it and anticlockwise to loosen. It’s held to the body of the launcher by a tightener with its screw. The top screw controls the hardness of the trigger (pull on), the middle screw manages the activation point (switch activation point) and the third screw, the bottom one, adjusts the length of the trigger (pull length). It is S-shaped and is adjustable on three points. The Clone GTi comes with a standard 0.691 insert. The inserts are inserted but unlike freak, they are inserted in the front instead of the back. The grip end is what makes it comfortable for small hands. There’s a good space between the trigger frame and the regulator. The controller does not have a grip but despite this, the grip is excellent. The grip is held by 3 screws on each side of the launcher. The clone GTi weighs 933 grams with battery and barrel. The grip of the handle has undergone a facelift. ErgonomyĮrgonomics is the same as for the Clone GT. We find in the partition separating the two compartments, a net that contains an allen key set, a glossy manual, a barrel sleeve with MacDev design, a tube of MacDev grease and a part kit containing the essentials parts. The second compartment contains the front and back with the 0.691 insert. The first compartment will hold your marker. The compartments are made of a rigid foam. The gun box opens with a horizontal zipper. It is a tissue box maintained in shape with rigid foams. The gun box of the clone GTi is the same as the GT clone. The gun box will be delivered in a box of classic design with MacDev clone GTi specifications. The innovations of the Clone GTi over the clone GT come from a new board with color OLED display, a new subplate with a pressure sensor, a new valve and a new grip. The Clone GTi is announced at about 1250€ customer price. The Clone GTi from Black Tiger is the Blue/Silver version. – weight: 933g (barrel and battery included) – Shift barrel 14 inches with 0.691 insert – Middle pressure highly recommended (a higher pressure could damage the solenoïd) The Clone GTi is the high-end marker from MacDev.